Hebei Medick Medical Device Technology Co., Ltd.

Product Ingredients
The main ingredient is mild weak acid, a cleaning agent that reacts against oxides. It also removes rust (oxides) and scale based on the principle of oxidation and reduction, and will not cause damage to the stainless steel itself. Corrosive rust remover. Neoglycolic acid avoids pungent odors while maintaining its original effects.
Scope of use
Suitable for manual soaking cleaning and ultrasonic machine cleaning.
How to use
.Dilution ratio [Rust removal] [Scale removal]
.Water temperature ~ ℃ water temperature has the best and fastest effect.
Dilution ratio [Hand wash] [Machine wash] ~
The temperature of the water is room temperature, but the higher the water temperature, the better it will help dry the equipment and avoid the formation of scale.
Operation method
For daily or frequent cleaning, the instrument needs to be fully opened and soaked for minutes (the instrument is severely rusted or the first time the rust remover is used, soak for at least ~ minutes, and may be extended as appropriate).
. Seriously rusted areas can be scrubbed with a brush dipped in diluent and then rust remover. For particularly severe rust, the soaking and scrubbing procedures can be repeated.
After the rust removal is completed, rinse with distilled water.
Product Features
Mild and slightly acidic solvent, it can remove rust and scale quickly and safely, and it will be effective within minutes, significantly saving a lot of equipment replacement costs.
It can remove various rust spots and corrosion caused by various stainless steel products during the high-pressure steam sterilization process.
Suitable for handling various endoscopic accessories, microsurgery, ophthalmology and other fine instruments and equipment.
It is also suitable for surface dirt, rust spots and rust on various trays, wash basins, carts, etc. in the operating room supply room.
Usage recommendations
. It cannot be used for suction in fully automatic cleaning machines. This product is weakly acidic and will produce foam when sprayed.
. To remove machine scale, you can put the product into a small bowl, place the bowl in the middle of the bottom layer of the cleaning machine, and run it to remove scale on the inner wall of the machine.
.Use according to the guided temperature and proportion. If there are too many instruments, the dosage can be increased appropriately.